Post general kiteboarding discussion topics here!
This concept could revolutionize kite design, especially for light wind. Stacking the kites closer for improved responsiveness could be experimented with. Imagine the quicker turning speed of a triple-stacked 5m kite (or 4/5/6) vs a regular 15m. Flotation requirements might be able to be eliminated for 2 of the kites and thus decrease total weight.
Didn't slingshot do a video like this like a year ago?
Kites: 2014 F-One Bandit VII: 10m and 8m. Trust II: 13m.
Board: 2014 F-One Spicy & 5'6 Fish.
Harness: Manera Exoharness.
Wetsuit: Underwave Sultan shortleg 4/3.
Here's a link to a couple vids showing a double stack in action: http://www.seabreeze.com.au/forums/Kite ... ked-kites/
Look how much more responsive it is than the big kites on that 2nd video.
Here's one where they're stacked tighter:
Imagine incorporating it into a single unit, with an elongated C-kite combined with a flat LEI.
Yeah the concepts been around for a while
Flexifoil's sizing was based around this. Want more power? Add more kites!
Two modern kites are okay, three gets messy. We used to do this with Arcs a bit. If doesn't feel quite as efficient upwind as one big kite. The kites above the top one lagg a little and slow the whole train down. Relaunch is a nightmare and self rescue is, well as bad as you'd expect. It's find for the novelty factor though.
It seems that fusing 2 kites into a single unit would minimize kite lag and self-rescue issues. Relaunch is crucial, but a little yankee ingenuity ought to solve that. Perhaps the closer kite's struts could lay flat on the water so the wind catches the slightly larger distal kite to move it around the window, then when it rolls onto it's side the closer kite would open out for launching.
The advantages of 2 smaller kites are many, not the least of which is the increased pressure they can hold without risk of rupture, thus increasing rigidity and responsiveness. Laplace's law states that the wall tension equals the pressure times the radius, so if you double the leading edge diameter, it can only hold half the pressure without rupturing. In addition, Pascal's principle states that the pressure is equal in all parts of the system, so the struts on a big kite won't have as much pressure as a smaller kite and won't be as rigid.
Users browsing this forum: No registered users and 3 guests